Mold Removal Cost In Alcoa, TN
A typical professional mold job in Alcoa runs about $1,400 to $5,550 before rebuild. Alcoa sits in Blount County.
1976Median year homes were built
55%Homes built before 1980
35%Homes rented, not owned
$232,300Median home value
5,455Housing units
11,635People
Half the homes in Alcoa were built before 1976, and 55 percent went up before 1980. Older plumbing, roofs and window seals are where slow leaks start, and slow leaks are the mold most home policies leave out. About 35 percent of homes in Alcoa are rented, so most households here carry an owner's policy on the building itself.
Typical Prices In Alcoa
| Job | Size | National Range | Alcoa Estimate |
|---|---|---|---|
| Mold Remediation | a typical professional job | $1,500 to $6,000 | $1,400 to $5,550 |
| Mold Remediation | an attic | $2,000 to $7,500 | $1,850 to $6,950 |
| Mold Inspection and Testing | a visual inspection | $200 to $600 | $200 to $550 |
| Mold Inspection and Testing | an inspection with samples | $300 to $1,000 | $300 to $950 |
| Mold Inspection and Testing | a clearance test | $300 to $800 | $300 to $750 |
The standard limited fungi endorsement caps mold at $5,000. Against a typical job here of up to $5,550, that cap falls short by about $550 at the top of that range. Read the form
Water Hazards FEMA Rates Here
FEMA rates none of the water hazards below as high for Blount County.
| Hazard | FEMA Risk Rating |
|---|---|
| Inland flooding | Relatively Moderate |
| Coastal flooding | Not Applicable |
| Hurricane | Very Low |
| Cold wave | Relatively Moderate |
| Winter weather | Relatively Moderate |
ZIP Code Neighborhoods In Alcoa
| ZIP | Median Year Built | Homes Rented | Median Home Value |
|---|---|---|---|
| 37701 | 1970 | 33% | $239,600 |
Tennessee Rules On Mold
Who May Do Mold Work
Tennessee has no stand alone mold inspector license. Instead, the Board for Licensing Contractors has a Mold Remediation classification on its contractor license. Tennessee requires a contractor license for jobs of $25,000 or more, so a large mold job should go to a company licensed in that classification.
State law does not bar one company from both inspecting and remediating the same job, so hiring an independent inspector is your own choice. You can check a contractor’s license and classification on the state’s online license lookup.