Mold Removal Cost In Farragut, TN
A typical professional mold job in Farragut runs about $1,400 to $5,550 before rebuild. Farragut sits in Knox County.
1992Median year homes were built
29%Homes built before 1980
15%Homes rented, not owned
$513,100Median home value
9,104Housing units
24,309People
Half the homes in Farragut were built before 1992, and 29 percent went up before 1980. Older plumbing, roofs and window seals are where slow leaks start, and slow leaks are the mold most home policies leave out. About 15 percent of homes in Farragut are rented, so most households here carry an owner's policy on the building itself.
Typical Prices In Farragut
| Job | Size | National Range | Farragut Estimate |
|---|---|---|---|
| Mold Remediation | a typical professional job | $1,500 to $6,000 | $1,400 to $5,550 |
| Mold Remediation | an attic | $2,000 to $7,500 | $1,850 to $6,950 |
| Mold Inspection and Testing | a visual inspection | $200 to $600 | $200 to $550 |
| Mold Inspection and Testing | an inspection with samples | $300 to $1,000 | $300 to $950 |
| Mold Inspection and Testing | a clearance test | $300 to $800 | $300 to $750 |
The standard limited fungi endorsement caps mold at $5,000. Against a typical job here of up to $5,550, that cap falls short by about $550 at the top of that range. Read the form
Water Hazards FEMA Rates Here
FEMA rates Knox County high for cold wave, winter weather. Water from these events is where mold claims start, and flood water is a separate policy. FloodSmart says mold damage is not covered under standard NFIP flood policies. FloodSmart
| Hazard | FEMA Risk Rating |
|---|---|
| Inland flooding | Relatively Moderate |
| Coastal flooding | Not Applicable |
| Hurricane | Relatively Low |
| Cold wave | Relatively High |
| Winter weather | Relatively High |
ZIP Code Neighborhoods In Farragut
| ZIP | Median Year Built | Homes Rented | Median Home Value |
|---|---|---|---|
| 37934 | 1991 | 14% | $473,600 |
Tennessee Rules On Mold
Who May Do Mold Work
Tennessee has no stand alone mold inspector license. Instead, the Board for Licensing Contractors has a Mold Remediation classification on its contractor license. Tennessee requires a contractor license for jobs of $25,000 or more, so a large mold job should go to a company licensed in that classification.
State law does not bar one company from both inspecting and remediating the same job, so hiring an independent inspector is your own choice. You can check a contractor’s license and classification on the state’s online license lookup.