Mold Removal Cost In Flowood, MS
A typical professional mold job in Flowood runs about $1,350 to $5,350 before rebuild. Flowood sits in Rankin County.
2000Median year homes were built
12%Homes built before 1980
42%Homes rented, not owned
$288,400Median home value
4,620Housing units
10,384People
Half the homes in Flowood were built before 2000, and 12 percent went up before 1980. Older plumbing, roofs and window seals are where slow leaks start, and slow leaks are the mold most home policies leave out. About 42 percent of homes in Flowood are rented, so most households here carry an owner's policy on the building itself.
Typical Prices In Flowood
| Job | Size | National Range | Flowood Estimate |
|---|---|---|---|
| Mold Remediation | a typical professional job | $1,500 to $6,000 | $1,350 to $5,350 |
| Mold Remediation | an attic | $2,000 to $7,500 | $1,800 to $6,700 |
| Mold Inspection and Testing | a visual inspection | $200 to $600 | $200 to $550 |
| Mold Inspection and Testing | an inspection with samples | $300 to $1,000 | $250 to $900 |
| Mold Inspection and Testing | a clearance test | $300 to $800 | $250 to $700 |
The standard limited fungi endorsement caps mold at $5,000. Against a typical job here of up to $5,350, that cap falls short by about $350 at the top of that range. Read the form
Water Hazards FEMA Rates Here
FEMA rates none of the water hazards below as high for Rankin County.
| Hazard | FEMA Risk Rating |
|---|---|
| Inland flooding | Relatively Moderate |
| Coastal flooding | Not Applicable |
| Hurricane | Relatively Low |
| Cold wave | Relatively Moderate |
| Winter weather | Relatively Moderate |
ZIP Code Neighborhoods In Flowood
| ZIP | Median Year Built | Homes Rented | Median Home Value |
|---|---|---|---|
| 39232 | 1999 | 46% | $293,000 |
Mississippi Rules On Mold
Mississippi Mold And Insurance Rules
- A home policy usually limits mold coverage. MID Consumer's Quick Guide To Homeowner's Insurance
- Insurers must give a checklist that says whether your home and belongings are insured against mold. MID Regulation 2007-1