Mold Removal Cost In Bartlett, TN
A typical professional mold job in Bartlett runs about $1,400 to $5,550 before rebuild. Bartlett sits in Shelby County.
1992Median year homes were built
27%Homes built before 1980
16%Homes rented, not owned
$283,700Median home value
20,818Housing units
56,998People
Half the homes in Bartlett were built before 1992, and 27 percent went up before 1980. Older plumbing, roofs and window seals are where slow leaks start, and slow leaks are the mold most home policies leave out. About 16 percent of homes in Bartlett are rented, so most households here carry an owner's policy on the building itself.
Typical Prices In Bartlett
| Job | Size | National Range | Bartlett Estimate |
|---|---|---|---|
| Mold Remediation | a typical professional job | $1,500 to $6,000 | $1,400 to $5,550 |
| Mold Remediation | an attic | $2,000 to $7,500 | $1,850 to $6,900 |
| Mold Inspection and Testing | a visual inspection | $200 to $600 | $200 to $550 |
| Mold Inspection and Testing | an inspection with samples | $300 to $1,000 | $300 to $900 |
| Mold Inspection and Testing | a clearance test | $300 to $800 | $300 to $750 |
The standard limited fungi endorsement caps mold at $5,000. Against a typical job here of up to $5,550, that cap falls short by about $550 at the top of that range. Read the form
Water Hazards FEMA Rates Here
FEMA rates Shelby County high for inland flooding, cold wave, winter weather. Water from these events is where mold claims start, and flood water is a separate policy. FloodSmart says mold damage is not covered under standard NFIP flood policies. FloodSmart
| Hazard | FEMA Risk Rating |
|---|---|
| Inland flooding | Relatively High |
| Coastal flooding | Not Applicable |
| Hurricane | Relatively Low |
| Cold wave | Very High |
| Winter weather | Relatively High |
ZIP Code Neighborhoods In Bartlett
Tennessee Rules On Mold
Who May Do Mold Work
Tennessee has no stand alone mold inspector license. Instead, the Board for Licensing Contractors has a Mold Remediation classification on its contractor license. Tennessee requires a contractor license for jobs of $25,000 or more, so a large mold job should go to a company licensed in that classification.
State law does not bar one company from both inspecting and remediating the same job, so hiring an independent inspector is your own choice. You can check a contractor’s license and classification on the state’s online license lookup.