Mold Removal Cost And Risk In ZIP 79010 TX
A typical professional mold job in ZIP 79010 runs about $1,400 to $5,500 before rebuild. Half the homes here were built before 1983, newer than the Potter County median of 1962.
1983Median year homes were built
33%Homes built before 1980
28%Homes rented, not owned
Not publishedMedian home value
Not publishedMedian gross rent
123Housing units
33 percent of homes in 79010 went up before 1980. Older plumbing, roofs and window seals are where slow leaks start, and slow leaks are the mold most home policies leave out.
About 28 percent of homes here are rented, against 44 percent across Potter County, so most households carry an owner's policy on the building.
Typical Prices In 79010
| Job | Size | National Range | 79010 Estimate |
|---|---|---|---|
| Mold Remediation | a typical professional job | $1,500 to $6,000 | $1,400 to $5,500 |
| Mold Remediation | an attic | $2,000 to $7,500 | $1,850 to $6,900 |
| Mold Inspection and Testing | a visual inspection | $200 to $600 | $200 to $550 |
| Mold Inspection and Testing | an inspection with samples | $300 to $1,000 | $300 to $900 |
| Mold Inspection and Testing | a clearance test | $300 to $800 | $300 to $750 |
The standard limited fungi endorsement caps mold at $5,000. Against a typical job here of up to $5,500, that cap falls short by about $500 at the top of that range. Read the form
Water Hazards FEMA Rates For Potter County
FEMA rates Potter County high for cold wave, winter weather. Water from these events is where mold claims start, and flood water is a separate policy. FloodSmart says mold damage is not covered under standard NFIP flood policies. FloodSmart
| Hazard | FEMA Risk Rating |
|---|---|
| Inland flooding | Relatively Low |
| Coastal flooding | Not Applicable |
| Hurricane | No Rating |
| Cold wave | Relatively High |
| Winter weather | Very High |
Texas Rules On Mold
Who May Do Mold Work
Texas licenses mold assessment consultants, assessment technicians, remediation contractors, remediation workers and the companies they work for through the Texas Department of Licensing and Regulation. A license is needed when the mold covers 25 contiguous square feet or more.
State law says a license holder may not do both the mold assessment and the mold remediation on the same project. A person also may not own a share of both the assessment company and the remediation company on the same project. You can check any license with the TDLR license search.
Nearby ZIP Codes In Potter County
Part of Potter County, Texas.