Mold Removal Cost In Kenmore, WA
A typical professional mold job in Kenmore runs about $1,650 to $6,650 before rebuild. Kenmore sits in King County.
1984Median year homes were built
43%Homes built before 1980
30%Homes rented, not owned
$869,800Median home value
9,362Housing units
23,594People
Half the homes in Kenmore were built before 1984, and 43 percent went up before 1980. Older plumbing, roofs and window seals are where slow leaks start, and slow leaks are the mold most home policies leave out. About 30 percent of homes in Kenmore are rented, so most households here carry an owner's policy on the building itself.
Typical Prices In Kenmore
| Job | Size | National Range | Kenmore Estimate |
|---|---|---|---|
| Mold Remediation | a typical professional job | $1,500 to $6,000 | $1,650 to $6,650 |
| Mold Remediation | an attic | $2,000 to $7,500 | $2,200 to $8,350 |
| Mold Inspection and Testing | a visual inspection | $200 to $600 | $200 to $650 |
| Mold Inspection and Testing | an inspection with samples | $300 to $1,000 | $350 to $1,100 |
| Mold Inspection and Testing | a clearance test | $300 to $800 | $350 to $900 |
The standard limited fungi endorsement caps mold at $5,000. Against a typical job here of up to $6,650, that cap falls short by about $1,650 at the top of that range. Read the form
Water Hazards FEMA Rates Here
FEMA rates King County high for inland flooding, winter weather. Water from these events is where mold claims start, and flood water is a separate policy. FloodSmart says mold damage is not covered under standard NFIP flood policies. FloodSmart
| Hazard | FEMA Risk Rating |
|---|---|
| Inland flooding | Very High |
| Coastal flooding | Relatively Moderate |
| Hurricane | Not Applicable |
| Cold wave | Relatively Low |
| Winter weather | Relatively High |
ZIP Code Neighborhoods In Kenmore
| ZIP | Median Year Built | Homes Rented | Median Home Value |
|---|---|---|---|
| 98028 | 1984 | 30% | $869,800 |
Washington Rules On Mold
Washington Mold And Insurance Rules
- Many Washington home policies give limited mold coverage, but only when a covered loss like a burst pipe causes it. Leaks, water damage and mold, Washington OIC
- If your Washington policy has no mold coverage, you may be able to add it. Leaks, water damage and mold, Washington OIC
- Washington landlords must give tenants state health department information about indoor mold. RCW 59.18.060
- Washington renters should tell the landlord in writing about leaks or moisture right away. Renters, Landlords, and Mold, WA Department of Health
All Washington Mold And Insurance Rules lines
Washington Office of the Insurance Commissioner
- Many Washington home policies give limited mold coverage only when the mold comes from a covered loss like a pipe that suddenly bursts. Leaks, water damage, and mold
- If your policy has no mold coverage you may be able to add it, but it is usually very limited. Leaks, water damage, and mold
- Check your crawlspace often for dampness, moldy smells and sagging insulation. Leaks, water damage, and mold